I advise using this tool to make sure surrounding ground is not below the river height otherwise water may 'leak' out.ĥ. Correct the terrain: Use the 'Soften Terrain' landscaping tool to smooth out any sections that may have appeared after aligning the slope. Smooth the slope: Use the Move It 'Align Slope' tool to ensure that all the river nodes are gradually descending.Ĥ. I recommend using the 'Freeform' network tool to create realistic curves as the river descends.ģ. Lay the river: Next it's time to plop the river along the ground you've sloped. Then use the 'Slope Terrain' tool to make an even slope from top to bottom following the route of the river, including all the curves and bends.Ģ. It's better if the slope is minimal for this pack as slow moving water looks more realistic in wide rivers. Prepare the ground: Once you've identified the course of your river check that the source will be higher than the estuary. The technique for these rivers can be different but they can still be used as an extension of the other packs.ġ. I highly recommend watching the tutorials and, at the very least, looking at the instructions for the 'Green Valley' or 'Rocky Mountain' river packs. ![]() How to lay down the rivers(There are images above relating to the sections below.)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |